Reinforcing Meshes Summary VIEW PDF
MESH & ACCESSORIES INDEX | MESH OVERVIEW | EIMA IMPACT CLASSIFICATION
 
STANDARD MESH    SPECIALTY MESH
Standard
    Short Detail
    Adhesive
    Corner Mesh
Weight    4.5 oz/yd2 (155g/m2)    4.5 oz/yd2 (155g/m2)    4.5 oz/yd2 (155g/m2)    7.2 oz/yd2 (249g/m2)
Coverage    475 ft2 (43.6m2)/roll    150 Ln.Ft. (45.7m/roll)    237 ft2 (21.7m2)/roll    150 Ln.Ft. (45.7m)/roll
Width    38 in. (96.5cm)    9.5 in (23.5cm)    19 in. (48.2cm)    9.5 in. (23.5cm)
Packaging    4 rolls/box    16 rolls/box    8 rolls/box    4 rolls/box
Storage    Avoid storing rolls on end or in direct sunlight.
Application    The fiberglass must be embedded into the wet base coat and be smoothed with a trowel until fully embedded with the mesh pattern not visible. Avoid wrinkles.

The mesh must be continuous at all corners and must be lapped a minimum of 2-1/2 inches (63.5 mm) at the mesh seams.		    Adhesive mesh 352 is adhered to the insulation before the base coat is applied. Apply the base coat and smooth it until the mesh pattern is not visible.

The mesh must be continuous at all corners and must be lapped a minimum of 2-1/2 inches (63.5 mm) at the mesh seams.		    The fiberglass must be embedded into the wet base coat and be smoothed with a trowel until fully embedded with the mesh pattern not visible.

Tightly butt mesh edges but do not overlap them.

Install mesh taking care to avoid wrinkles.

Where mesh edges butt together, the joint has to be covered with a layer of Standard or Detail mesh with a minimum lap of 6 in. (152mm).

IMPACT MESH
6 oz.
    Intermediate Impact 10
    High Impact 14
    Ultra-High Impact 20
Weight    6 oz/yd2 (207g/m2)    12 oz/yd2 (346g/m2)    15 oz/yd2 (484g/m2)    20 oz/yd2 (692g/m2)
Coverage    475 ft2 (43.6m2)/roll    237 ft2 (21.7m2)/roll    237 ft2 (21.7m2)/roll    247 ft2 (43.6m2)/roll
Width    38 in. (96.5cm)    38 in. (96.5cm)    39 in. (99cm)    38 in. (96.5cm)
Packaging    4 rolls/box    4 rolls/box    4 rolls/box    1 roll/box
Storage    Avoid storing rolls on end or in direct sunglight.
Application    The fiberglass must be embedded into the wet base coat and be smoothed with a trowel until fully embedded with the mesh pattern not visible.

Tightly butt mesh edges but do not overlap them.

Install Parex Corner Mesh 357 at all edges.

Where mesh edges butt together, the joint has to be covered with a layer of Standard or Detail mesh with a minimum lap of 4 in. (102 mm). For High impact 14 and Ultra-High impact 20, a second coat of Standard or Long Detail mesh must be applied on the whole surface.

 

© 1997-2008 ParexLahabra, Inc. All rights reserved.

Locate Distributors | Locate Medallion Applicators